Greenerymine was some boxwood from Walmart as my dollar tree didn’t have any good greenery
Hot Glue Gun/ glue sticks
Instructions
Start by cutting the tile into a triangle shape ( I did the general shape and then trimmed it down so it looked more like a carrot)
Apply 2 coats of the chalk paint allowing for time to dry in between. Make sure to paint in the same direction so it covers all of the raised sections and won’t rub off
While that is drying you can start on the bow. I cut a 7 inch piece of burlap ribbon and an 8 inch piece of the pin stripe ribbon. Place the pin stripe ribbon over the burlap ribbon and over lap the ends. Cut a 4 inch section of pin stripe ribbon. Pinch the middle together and wrap the pin stripe ribbon over the center and secure with hot glue.
Cut a piece of cardboard so that it covers the majority of the backside of the carrot, this will make the tile more stable.
Hot glue the piece of cardboard to the backside of the tile.
Pull off pieces of the boxwood from the stem or you could cut them with a wire cutter if needed.
Attach them to the backside of the tile on top of the cardboard with hot glue.
Next add some hot glue to the backside of the bow and attach to the top front of the tile.